@article{oai:ynu.repo.nii.ac.jp:00010192,
 author = {Sato, Yosuke and Koizumi, Hiroyuki and Nakano, Masakatsu and Takao, Yoshinori},
 issue = {24},
 journal = {Journal of Applied Physics},
 month = {Dec},
 note = {This study analyzes the dependence of electron extraction efficiency, which is defined as the ratio of the extracted electron current to the generated electron current, on the orifice shapes and magnetic fields of a miniature microwave discharge xenon neutralizer via three-dimensional particle-in-cell simulations with Monte Carlo collisions (PIC–MCCs). The PIC–MCC simulation results show that the orifice shapes do not significantly affect the discharge characteristics or the electron extraction efficiency. However, the efficiency achieves a 1.5-times higher value in a new magnetic field configuration, referred to as MF-2, where the magnetic field lines pass through nearly the entire area of the orifices. This improvement is attributed to the reduction in the electron backflow and the electron loss toward both the downstream inside surface and the outside wall of the discharge chamber. In addition, there are relatively small plasma fluctuations in the discharge chamber for MF-2 due to its low Bohm diffusion coefficient, where no rotating spokes, which are often seen in other E ×B devices, are observed. As a result, the electron loss toward the downstream surface inside the discharge chamber is reduced, and this decrease in the electron loss also contributes to the increase in the extraction efficiency., This article may be downloaded for personal use only. Any other use requires prior permission of the author and AIP Publishing. This article appeared in Y. Sato et al., Jnl. of App. Phy. 126, 243302 (2019) and may be found at https://doi.org/10.1063/1.5127805.},
 title = {Electron extraction enhancement via the magnetic field in a miniature microwave discharge neutralizer},
 volume = {126},
 year = {2019}
}